3) Remove 1 piece of E Ring (E3) (4) on the handle side.
Remove E Ring (E5) (5) and Oilless Metals (6) at both sides to remove the Supporting Shaft 1 (7).
As you will find the Stay Assembly, lubricate it at this time.
If you will replace the Stay Assembly, go to the next step.
6
5
4) Remove E Ring (E5) (8) and Oilless Metals (9) at both sides, remove the Spring (10) on the
handle side, and then remove the
Replace the Stay Assembly (11) with the new one.
NOTE
Do not remove the Side Plates of Cutter Unit when you remove the Stay Assembly.
If you remove Side Plates, it is necessary to re-adjust the home position of Cutter Blade.
5
7
Stay Assembly
(11).
5-52
4
5
6
7
5
4
K115sm5e4.doc