KIP 9000 Service Manual page 507

7. 2. 3. 6 "E-09" Web End Error
Cause Order
Web Cleaner
Harness
Installation of Web roll
Web Sensor (PH40)
Main Control PCB
(PW11520)
7. 2. 3. 7 "E-13" Paper Feed Motor Error
When "E-13" must not be detected when diagnosing the KIP9000, mask it in the Error Mask Mode.
Its Mask Code is "03". See [8.1.8 Error Mask Mode (Sub Mode 7)] on page 8-114 for the detail.
Cause Order
Harness
Paper Feed Motor
(M2)
Or Paper Feed Motor
Controller PCB
(TP0362)
Main Control PCB
(PW11520)
Checking matter
1 Clear the Web End Error in any of
Service Modes 5-9E to A0 at first.
(See NOTE on the page 8-110 for
the detail.) After that check if the
web is remaining or not. Is the
Web ended?
2 Is the harness connected to each
Web Sensor (PH40) and Main
Control PCB (PW11520)?
3 Is the Web roll correctly installed?
4 Check the input signal from the
Web Sensor (signal code 36) in
the Input/Output Checking Mode
of Service Mode.
Does the status change when the
actuator block the sensor light?
5 Can the error be fixed by
replacing the Main Control PCB?
Checking matter
1 Is the harness connected to each
Paper Feed Motor, Paper Feed
Motor Controller PCB and DC
Driver PCB?
2 Can the Paper Feed Motor (signal
code : 84) be operated properly in
the Function Checking Mode of
Service Mode?
3 Can the error be fixed by
replacing the Main Control PCB?
7-20
Result Treatment
Yes Measure the thickness of Web roll,
and input that value in the Service
Mode 5-A1.
No Replace the Web. Set the Web
Operation Time back to 0hour
0minute 0second in the Service
Mode 5-A0.
No Connect it.
No Install it correctly.
No Replace the Web Sensor.
Yes OK
Result Treatment
No Connect it.
No Replace either Paper Feed Motor or
Paper Feed Motor Controller PCB.
Yes OK
K115sm7e1.doc