5. If the Negative Developer Bias from BIAS to Developer Roller does not satisfy -250V +/-3V,
readjust it to satisfy the requirement.
To adjust it, select the Adjustment Mode 0 (Sub Mode No.4) and select the Item No.19
(Developer Bias).
•
Refer to [8.1.5.3 Operation] on the page 8-36 for how to change the setting value.
•
Refer to [(19) Developer Bias (applied when Auto Density Control is set to OFF) (No.19)]
on the page 8-62 as for the contents of the setting.
CAUTION
Do not adjust the Negative Developer Bias by rotating the VR2 on BIAS positively as it is
properly adjusted before shipment!
MENU
ENTER ONLINE
4-86
K115sm4ea.doc