Unpacking - KIP 9000 Service Manual

2.2

Unpacking

2. 2. 1 Unpacking
CAUTION
When the printer is to be installed in winter condensation may occur! The printer will be very
cold if it has been kept in a warehouse or delivered by truck. If a cold machine is unpacked on
the customer site right after it's delivery, condensation will occur and cause issues. In such
cases, leave the KIP9000 at the installation site for at least 6 hours without removing its
package. Only if the printer is warmed to room temperature, then start the installation.
Be careful not to be harmed during installation as it is heavier than 400Kg. (880 lbs)
NOTE
Toner and media are not included in the package. Please purchase them separately.
1. Remove the top crate and 4 side crates.
2. Remove the wrapping film and the protection paper from KIP9000.
Confirm that the product includes the following items.
A : Drum Package
B : LED Head Package
C : Manual Tray
D : Drum Stand and 36"x5" paper
3. Lift up the KIP9000 using a folk lift, with the forks set to the widest possible position to fit into
the inner skid, and place the KIP9000 directly onto the floor.
4. Remove the plastic.
5. Remove the wrapping film.
A
B
E
G
E : Setup Procedure and User's Manual
F : Setup Toner Bottle (Inside of the Right Side Door)
G : Monitor parts (inside lower deck)
H : Controller case (packed on back)
2-3
C
D
D
F
H