Current Setting For The Image Corona Wire (No.1A) - KIP 9000 Service Manual

(19) Developer Bias (applied when Auto Density Control is set to OFF) (No.19)
It is possible to adjust the Developer Bias supplied to the Developer Roller. The Bias specified
here is directly applied when the Auto Density Control is set to OFF. The setting unit is
hexadecimal, and the setting range is from 000 to 0FF. More negative Bias is provided to the
Developer Bias when the value is increased, which makes the print image darker.
NOTE
Make sure to adjust the Developer Bias in this item No.19. Do not adjust the Bias by
moving the volumes on the Bias Board, as they have been adjusted and locked in the
factory.

(20) Current setting for the Image Corona Wire (No.1A)

Intensity of current that flows on the Image Corona Wires can be adjusted. The setting unit is
hexadecimal, and the setting range is from 000 to 0FF. If the value is increased, Drum will be
charged more negative as more current flows on the Image Corona Wire.
Developer Roller
8-62
Image Corona Wires
K115sm8e2.doc