KIP 9000 Service Manual page 380

NOTE
Make sure to close the Process Unit without
tightening the M4x10 screws (7).
The Positioning Bars of the LED Head are fitted into the slits of the Process Unit.
Slits
These Positioning Bars are curved upward, and the LED Head is smoothly moved up when
the bars are fitted into the slits. By this, a proper gap can be kept between LED Head and
Drum.
Slit
Process Unit
If you close the Process Unit when the LED Head is not movable being fixed with the M4x10
screws, the gap between LED Head and Drum is not adjusted properly. Or you may bend the
Positioning Bars in the worst case.
Tightened
LED Head
Bar
Drum
Bar is bent.
5-168
7
Positioning Bars
Proper gap
Gap is not
proper
K115sm5eC.doc