KIP 9000 Service Manual page 238

3) Remove 7 M4x6 tooth washer screws (4) to remove the
Replace the Bracket 581
NOTE
(1) The rubber plate of the Bracket 581 (5) touches the Regulation Roller and scrapes off the
toner.
Please provide a little toner onto the edge of rubber plate when you install the new
Bracket 581 (5), as it can reduce the friction between rubber plate and Regulation Roller.
If you do not, the rubber plate may be turned over by the friction and may be broken.
(2) Screw holes of the Bracket 581 (5) are oval.
Please tighten the screws (4) at the center of each oval hole.
If not tightened at the center (Bracket 581 is shifted to either side), the rubber plate may be
bent because it touches the Developer Side Plate, which results in a poor cleaning.
(3) Before putting back the Developer Unit to the Process Unit, please confirm that the rubber
plate of Bracket 581 (5) surely scrapes off the toner from the Regulation Roller.
Also, please confirm the rubber plate is not turned over by the friction even if you rotate the
Regulation Roller.
(7) with the new one.
4
Rubber plate
5-26
Bracket 581 (5) and the Holder Spring (6).
4
5
6
K115sm5e3.doc