Fuser Motor Speed (Bypass Feed) (No.27 To 32) - KIP 9000 Service Manual

(25) Fuser Motor Speed (Bypass feed) (No.27 to 32)

The speed of Fuser Motor can be adjusted. This setting is applied when the print media is fed
from the Bypass Feeder. The adjustment unit is "0.05%", and the adjustment range is from -1.0%
to +1.0%. Increment of the value makes the speed of Fuser Motor faster.
Each Item No. has its own target media type and media size.
Please adjust the proper item.
Item No. Target media type
27 Plain paper
28 Plain paper
29 Plain paper
2A Plain paper
2b Tracing paper
2C Tracing paper
2d Tracing paper
2E Tracing paper
2F Film
30 Film
31 Film
32 Film
NOTE
(1) Media sizes are classified into 4 levels as follows.
Metric (Width)
Large A0 and B1
Medium A1 and B2
Small A2 and B3
Smallest A3
(2) Item No.27 to 32 are "dual value items" that are available to set both "Standard Setting
Value" and "Special Setting Value".
Refer to [(10) Standard / Special Setting Value Changing Modes (Items No.09, 0A & 0b)]
on and after the page 8-51 for the detail.
Target media size
Large
Medium
Small
Smallest
Large
Medium
Small
Smallest
Large
Medium
Small
Smallest
Inch (Width)
36", 34" and 30"
24" and 22"
18" and 17"
12" and 11"
8-65 K115sm8e2.doc