Te Margin Compensation (No. C2 To C5) - KIP 9000 Service Manual

(35) TE Margin Compensation (No. C2 to C5)

It is possible to select any compensation level which avoids the variation of TE margin caused by
the variation of roll thickness. Selectable setting values are 0, 1, 2 and 3.
Setting value (Compensation level
of TE margin)
0
1
2
3
Each Item No. has its own target Roll Deck.
Please adjust the proper item.
Item No. Target Roll Deck
C2 Roll 1
C3 Roll 2
C4 Roll 3
C5 Roll4
[Description]
When printed with both thick (new) and narrow (near empty) roll media respectively, the lengths of
trailing margin on both printouts will be different from each other. In general the TE margin tends to
become shorter than what it must be when printed with a narrower roll media. That is to say, more
TE margin should be provided as the thickness of roll is reduced for getting the same TE margin
always without affected by the variation of roll thickness.
Thick roll media
In the Items No. C2 to C5 it is possible to select any best TE Margin Compensation Level. More TE
margin is added if larger level is selected. See the next page.
Description (length of added TE margin)
1/8 2/8 3/8
0.0 0.0 0.0
0.0 +0.2 +0.4
0.0 +0.4 +0.8
0.0 +0.6 +1.2
Narrow roll media
Difference of trailing margin
8-74
Unit : mm
4/8 5/8 6/8 7/8
0.0 0.0 0.0 0.0
+0.6 +0.8 +1.0 +1.2
+1.2 +1.6 +2.0 +2.4
+1.8 +2.4 +3.0 +3.6
K115sm8e2.doc
8/8
0.0
+1.4
+2.8
+4.2