KIP 9000 Service Manual page 33

NOTE
Make sure to close the Process Unit with the M4x10 screws loosed!
The positioning bars (25) of the LED Head will fit into the positioning slits (26) when the
Process Unit is closed. The positioning bars (25) are curved up so that they can fit into the
positioning slits (26) vary smoothly. When the bars fit into the slits, the whole LED Head Unit is
moved up and a correct gap (focus distance) can be kept between LED Head and Drum.
Slit
Bar
If the Process Unit is closed when M4x10 screws are tightened, the LED Head can not move
up. This state can not have a proper gap (focus distance) between LED Head and Drum, and
will bend the positioning bars (25) .
Tightened
LED Head
Drum
LED Head can
not move
Bar is bent.
2-20
Proper gap
Gap is not
proper