KIP 9000 Service Manual page 267

6) Rotate the Cutter Handle until the cutting point (11) of Cutter Blade touches the HP Adjustment
tool 2 (10).
When the cutting point (11) touches the HP Adjustment tool 2 (10), fix the Joint A (8) tightening
Set Screws (7).
The gap between cutting point and base of Cutter Unit becomes 16mm by this operation.
When you have tightened the Set Screws (7), remove only the HP Adjustment tool 2 (10).
(Leave the HP Adjustment Assembly (9) as it is.)
7) Loosen 2 pieces of bind head screw (12) which fix the
Cutter Handle.
Rotate the Cutter Handle until the green area can be
seen in the notch (13).
When the green area can be seen in the notch (13),
tighten the bind head screws (12).
8) Remove the HP Adjustment Assembly (9).
Then, reassemble the Cutter Unit in the reversed order.
11
16mm
10
5-55
7
9 8
12
13
K115sm5e4.doc
10