Table of Contents
Advertisement
(14) Density Control Mode : Manual execution of control (0C)
It is possible to execute Density Control manually.
1. Indicate the Item Number "0C" on the 2nd digit. After confirming that "- -" on 5th and 6th digits
is lighting, press the [ ENTER ] Key to start Density Control. The 5th and 6th digits indicate
"8 8" in flashing during toner supply.
2. When the printer finishes Surface potential Control, "- -" lights on 5th and 6th digits again.
MENU
ENTER ONLINE
MENU
ENTER ONLINE
"8 8" flashes during Surface Potential Control.
MENU
ENTER ONLINE
MENU
ENTER ONLINE
8-144
K115sm8e4.doc
Advertisement
Chapters
Table of Contents
