KIP 9000 Service Manual page 40

27. Remove the Drum (43) from the box, fit both Drum Bearings (44) into the Drum Guides (45) on
both sides of Process Unit with placing the Drum Gear (46) on the left, and carefully bring
down the Drum along with the Drum Guides.
44
45
NOTE
The Drum Shaft inside of KIP9000 has 2 Driving Pins (47), and the Drum Bearing on Drum
Gear side has 2 Projections (48). Driving Pins (47) hold the Projections (48) when the Drum
Shaft rotates, so the Drum is rotated.
47
If the Process Unit is closed when both Driving Pins (47) and Projections (48) are at the same
position, the Driving Pins (47) will be bent or broken as the projections (48) will hit them.
The Dents (49) on the Drum Shaft show the position of Driving Pins (47) on another side, and
the Marking Lines (50) on outside of Drum Bearing show the position of internal Projections
(48). Rotate the Drum by hand so that the Dents (49) and Marking Lines (50) do not overlap
with each other (cross position), then close the Process Unit. This will prevent the Driving
Gears (47) from being bent.
47
49
2-27
46
43
48
50