Separation Lamp On / Off (Film) (No.c6) - KIP 9000 Service Manual

(36) Separation Lamp ON / OFF (Film) (No.C6)

It is possible to decide whether or not the Separation Lamp lights. This setting is applied when a
film is used. There are 2 selectable settings.
Setting value Description
0 Separation Lamp does not light during the print cycle.
1 Separation Lamp lights during the print cycle.
NOTE
(1) No.C6 is set to "0" (Lamp does not light) in default state. But the Separation Lamp may
become a solution for getting a better transfer result when some specific type of film is
used. It will be valuable to try to turn ON the Separation Lamp if transfer result looks not
satisfactory.
(2) Switch between ON / OFF can be done also in the User Mode 6. See Refer to [8.2.6 User
Mode 6 (Transfer Support LED ON/OFF [Film])] on the page 8-174.
Neither Service Mode nor User Mode has the setting priority. The final setting on either
modes become active.
(Separation Lamp is called "Transfer Support LED" in User Mode.)
Separation Lamp
8-76 K115sm8e2.doc