9) Swing the "Drum Gauge for Transfer Guide" forward and backward to check whether or not its
pins touch the Transfer Guide Plate (15).
One of 2 pins marked with 0.75mm (16) should not touch the Transfer Guide Plate (15).
Another pin marked with 1.25mm (17) should touch the Transfer Guide Plate (15) slightly.
If the above conditions are satisfied, the gap is between 0.75mm and 1.25mm.
17
Diameter of Drum
1.25mm pin
Transfer Guide Plate
1.25mm pin should touch the Transfer
Guide Plate slightly.
NOTE
Please check not at one point but entirely along the Drum Shaft.
0.75mm pin
5-227
16
15
Diameter of Drum
1.25mm pin
Transfer Guide Plate
0.75mm pin should not touch the Transfer
Guide Plate.
0.75mm pin
K115sm5eG.doc