KIP 9000 Service Manual page 545

8. 1. 3 Data Monitoring Mode (Sub Mode 2)
8. 1. 3. 1 Function
It is possible to monitor several data as the input voltage to the DC Controller PCB or the
temperature of Fuser.
8. 1. 3. 2 Indication on the Operation panel
The 1st digit from the left indicates "2" which is the Sub Mode number of "Data Monitoring Mode".
The 2nd digit indicates the Data Number.
The 4th, 5th and 6th digits indicate the data.
Sub Mode Number of Data Monitoring Mode
Data Number
Data
The following list shows the selectable Data Number and its Description.
Data Number
00 Fuser Temperature
01 Input from Paper Size Sensors of
Roll Deck 1
02 Input from Paper Size Sensors of
Roll Deck 2
03 Input from Paper Size Sensors of
Roll Deck 3
04 Input from Paper Size Sensors of
Roll Deck 4
05 Input from Cut Sheet Size Sensors
06 Roll 1 remaining level
07 Roll 2 remaining level
08 Roll 3 remaining level
09 Roll 4 remaining level
0A Humidity of machine inside
0b Input Voltage from Humidity Sensor
0C Drum Surface Potential
0d Input Voltage from SPS
0E Temperature of machine inside
0F (Reserved)
10 Toner remaining level Data 1
(1st checking)
11 Toner remaining level Data 2
(2nd checking)
12 Toner remaining level Data 3
(3rd checking)
Contents
8-20
MENU
Unit of the
indicated data
Centigrade
Hexadecimal 0: Paper is detected.
1: Paper is not detected.
Hexadecimal 0: Paper is detected.
1: Paper is not detected.
Hexadecimal 0: Paper is detected.
1: Paper is not detected.
Hexadecimal 0: Paper is detected.
1: Paper is not detected.
Hexadecimal 0: Paper is detected.
1: Paper is not detected.
Every 1/8 is indicated.
%
V
V
V
Centigrade
X / 8 0: Toner is not detected.
Hexadecimal 1: Toner is detected.
X / 8 0: Toner is not detected.
Hexadecimal 1: Toner is detected.
X / 8 0: Toner is not detected.
Hexadecimal 1: Toner is detected.
ENTER ONLINE
Remarks
K115sm8e1.doc