KIP 9000 Service Manual page 668

(13) Density Lock Mode : Setting of Target Density (0b)
It is possible to set new Target Density and make the KIP9000 memorize it.
NOTE
Normally it is unnecessary to set new Target Density as it has been already adjusted properly
in the factory. It is not recommended to use this mode in the field except for some special
case.
1. Indicate the Item Number "0b" on the 2nd digit. After confirming that "- -" on 5th and 6th digits
is lighting, press the [ ENTER ] Key to start Density Lock operation. The 5th and 6th digits
indicate "8 8" in flashing during toner supply.
2. When the printer finishes Density Lock operation, "- -" lights on 5th and 6th digits again.
The Target Density is automatically refreshed.
MENU ENTER ONLINE
MENU ENTER ONLINE
"8 8" flashes during Surface Potential Control.
MENU ENTER ONLINE
MENU ENTER ONLINE
8-143 K115sm8e4.doc