2. 9. 2
Roll deck 4
The method of installation to Roll 4 is a little different from the method for the other Rolls because of the
different location of Roll 4's feeding rollers. This section instructs the operation required for Roll 4. Refer
to [10.1 Roll 1, 2 & 3] on page 2-55 for the common operations.
1. Open the bottom Roll Deck (1).
2. Remove the Roll Spool from the Roll Deck, pull
out the Roll Spool from the old roll media, and
set the new roll media onto the Roll Spool.
NOTE
Please keep the correct direction as the following left photo.
(It is the same way you make for Roll 1, 2 & 3.)
Correct
1
Wrong
2-55