KIP 9000 Service Manual page 251

NOTE
(1) There is a projection beside the installation position of Regulation Roller. Align the edge of
this projection with the ends of Seal 13 and Seal 14. It is no problem even if another ends
of Seal 13 ad Seal 14 are not aligned with each other.
Not necessary to align here.
(2) When pasting the Seal 13, put it on the Seal 14 without stripping off the protection paper,
place it at its correct position, strip off the protection paper to reveal the sticky face, and
firmly paste it onto the Seal 14. (There is very small space between "triangle" and Seal 14.
If you strip off the protection paper first then try to set the Seal 13, it will be very difficult to
place the Seal 13 correctly as the "triangle" forces the sticky side of Seal 13 to contact on
the Seal 14.)
Triangle
Seal 13
Place the Seal 13 at the correct position
first. After that strip off the protection paper.
Seal 14
5-39
Align here.
Projection
K115sm5e3.doc