Input From Paper Size Sensors (01 To 04) - KIP 9000 Service Manual

(2) Input from Paper Size Sensors (01 to 04)

Input from Paper Size Sensors (for roll media) is shown by the hexadecimal data.
To check the input situation, convert the hexadecimal into binary. Each of 8 digits of binary data is
related with size sensors as follows.
Example) When "70" is indicated.
70
"0" means "Paper is detected", and "1" means "Paper is not detected". In this example
PH5, 6, 7 and 8 detect the paper (ON) while PH9, 10, 11 and 41 do not detect (OFF).
Reference
This mode is available to check if the size sensor is broken or not.
Supposing you check the input condition when an A0 roll (841mm wide) is loaded to the 2nd
Roll Deck, PH9 is suspected to be broken if "50" is indicated as it means "0 1 0 1 0 0 0 0".
("40" will be indicated if the PH9 is working properly, which means "0 1 0 0 0 0 0 0")
NOTE
The arrangement of sensors is different between Roll 1 and other Roll.
Note that the indicated hexadecimal data of Roll 1 will be different from that of other decks if
same roll paper is used.
Please refer to the explanation on and after the next page to avoid misunderstanding.
MENU
0 1 1 1 0 0 0 0
8-23
ENTER ONLINE
Hexadecimal data
PH5 (Paper Size Sensor Signal 0)
PH6 (Paper Size Sensor Signal 1)
PH7 (Paper Size Sensor Signal 2)
PH8 (Paper Size Sensor Signal 3)
PH9 (Paper Size Sensor Signal 4)
PH10 (Paper Size Sensor Signal 5)
PH11 (Paper Size Sensor Signal 6)
PH41 (15" Size Sensor Signal: Roll 1 only)
Not used (always "0": Roll 2, 3 & 4)
K115sm8e1.doc