Calculate:obwidth:lmask[1]|2:Segment:first:right:span <Frequency; Calculate:obwidth:lmask[1]|2:Segment:first:right:span; Calculate:obwidth:lmask[1]|2:Segment:second On|Off|1|0; Calculate:obwidth:lmask[1]|2:Segment:second - Agilent Technologies N1996A-503 User Reference

Mode
Occupied Bandwidth Measurement
Remote Command
Example
Notes
Dependencies /
Couplings
Preset
State Saved
Min
Max
Key Path
Default Unit
2nd Segment
Sets the state of the first segment to On or Off. This key is available only when 2
selected with the Segments key.
Mode
Remote Command
Example
Notes
Dependencies /
Couplings
116
:CALCulate:OBWidth:LMASk[1]|2:SEGMent:FIRSt:RIGHt:SP
AN <frequency>
:CALCulate:OBWidth:LMASk[1]|2:SEGMent:FIRSt:RIGHt:SP
AN?
:CALC:OBW:LMAS1:SEGM:FIRS:RIGH:SPAN 1.75 MHz
Key is only displayed when the selected segment is 2
selected segment side is Right.
st nd
If the Center, 1 , and 2
span adjusts on a change in the right 1
Not affected by a preset but set per default to 2 MHz after a
power cycling
Saved in instrument state.
0 Hz
See Dependencies / Couplings
Meas Setup, Limit Masks, Limit Mask 1, 1st Segment: Right Span
Hz
SA

:CALCulate:OBWidth:LMASk[1]|2:SEGMent:SECond

ON|OFF|1|0
:CALCulate:OBWidth:LMASk[1]|2:SEGMent:SECond?
:CALC:OBW:LMAS1:SEGM:SEC ON
Key is only displayed when the selected segment is 2
nd
If Off the 2 limit mask segment will not be displayed even if
turned On.
If On, and the First and Center segments are On:
nd
The left hand side 2 segment is drawn to the left hand side of
the left first segment at the specified power level
st
The right hand side 1 segment is drawn to the right hand side
of the right first segment at the specified power level
nd
segments On, the right 2
st
segment span.
"1st Segment" on page
nd
nd
, and the
segment
112.
has been
nd
.
Chapter 3