Agilent Technologies N1996A-503 User Reference page 165

Off Turns averaging functions off.
Example
Key Path
Exponential Sets the
Averaging
each successive data acquisition is exponentially weighted and combined with the existing
average. This weights new data more than the old data, which facilitates tracking of slow
changing signals.
Example
Key Path
Repeat Sets
Avg Mode
to the repeat function. Repeat averaging updates the trace after the
selected number of sweeps has been averaged. It is not updated again until the next set of
data from "Average Number" sweeps has been collected.
Example
Key Path
Max Hold In
Max Hold
the analyzer maintains and displays a max hold trace, which
represents the maximum data value on a point-by-point basis of the new trace data and
previous trace data. Pressing the
Max Hold,
causes the trace to be cleared and causes the
Example
Key Path
Repeat Max Hold Sets
Avg Mode
captures and holds the highest magnitude data at the end of each sweep count. Repeat
with max hold updates the trace after the selected number of sweeps has been made. It is
not updated again until the next set of data from "Average Count" sweeps has been
collected.
Chapter 3
TPIL:AVER OFF
Meas setup, Avg Mode, Off
function to exponential. With exponential averaging mode,
TPIL:AVER:TCON EXP
Meas setup, Avg Mode, Exponential
TPIL:AVER:TCON REP
Meas setup, Avg Mode, Repeat
Max Hold
key for the selected trace sets the trace type to
TPIL:AVER:TCON MAXH
Meas setup, Avg Mode, Max Hold
to repeat with max hold function. Repeat with max hold
Two Port Insertion Loss Measurement
Max Hold
sequence to be restarted.
Mode
165