View/Display (Spectrum Analyzer Mode) - Agilent Technologies N1996A-503 User Reference

Example
Preset
Byte Order (Remote Command Only)
This command selects the binary data byte order for data transfer. It controls whether
binary data is transferred in normal or swapped mode. This command affects only the byte
order for setting and querying trace data for the :TRACe[:DATA] and query
:TRACe[:DATA]? commands.
Normal mode is when the byte sequence begins with the most significant byte (MSB) first,
and ends with the least significant byte (LSB) last in the sequence: 1|2|3|4. Swapped
mode is when the byte sequence begins with the LSB first, and ends with the MSB last in
the sequence: 4|3|2|1.
Remote Command
Example
Preset

View/Display (Spectrum Analyzer Mode)

Displays keys to set the display to spectrogram views (spectrum analyzer mode only), or to
select which measurement values to display with the current measurement mode.
Dependencies / Couplings:
Chapter 3
FORM:DATA ASCii
With 4 points looks like:
–5.87350E+01, –5.89110E+01, –5.87205E+01,
–5.12345E+01<NL><END>
FORM:DATA INT,32
With 4 bytes per point looks like:
#216<16 bytes of data><NL><END>
Where the 2 in the #216 means "2 digits of numeric data to follow",
and the 16 is the 2 digits and means "16 binary bytes to follow" (this
is the definite length block format).
ASCii
:FORMat:BORDer NORMal|SWAPped
:FORMat:BORDer?
FORM:BORD SWAP
NORMal
The features available under the View/Display key vary
depending on the current Mode selected, and on the current
Measurement.
Meas Off (Spectrum Analyzer) Measurement
Mode
87