Agilent Technologies N1996A-503 User Reference page 208

Mode
Return Loss
Meas
In the Stimulus Response mode,
Stimulus Response mode. The measurement runs using the current default setup. Or you
can change settings for your unique measurement requirements. Settings can be changed
using the functions available under the
To configure measurement settings, select
Control/Sweep
Use to restart the currently selected measurement and change the sweep
points. To select between continuous or single measurements, press the
front-panel keys. For information about controlling sweep, refer to
page 98.
Mode
Range
Key Path
Meas Setup
Meas Setup
accesses a menu of keys to set up the Return Loss measurement. This section
describes the menu keys available with
Meas, Return loss
measurement, select
Mode
Key Path
Avg Mode
Sets the type of termination control used for the averaging function. This determines the
type of averaging used for the specified number of measurements.
Mode
Preset
Range
Key Path
208
Meas
accesses a menu of keys associated with the
Meas Setup
Return Loss
Stimulus / Response
Two Port Insertion Loss | One Port Insertion Loss | Return Loss
| Distance to Fault
Front-panel key
Return loss
.
Stimulus / Response
Front-panel key
Stimulus / Response
Exponential, ON
Off | Exponential | Repeat | Repeat Max Hold
Meas Setup, Avg Mode
key.
Meas Setup
and then press
Cont
"Control/Sweep" on
measurement selected. To turn on the
.
Single
or
Chapter 3