Agilent Technologies N1996A-503 User Reference page 152

Mode
Two Port Insertion Loss Measurement
Result # Field Name
1–256 Insertion Loss Trace
257 Average Insertion Loss
258 Valid Calibration
259 Calibration/Measurement
Mode
260 Start Frequency
261 Stop Frequency
262 Automatic Source
Amplitude
263 Source Amplitude
264 Average Type
265 Num Averages
266 Interference Mode
267 Optimization Mode
268 Average Count
269 Time Stamp
Seconds
152
Description
Insertion Loss trace (dB)
Average Insertion Loss of the trace (dB)
Indicates if there is a valid calibration
(0 = false, 1 = true)
8 = calibrate,
9 = measure insertion loss
(un-calibrated),
10 = measure normalized insertion loss
In Hz
In Hz
Automatically or manually set the
Source Amplitude for the sweep
(0 = manual, 1 = automatic)
Power output of the source for the sweep
(dBm)
0 = no averaging
1 = exponential average
2 = max hold
3 = repeat average
4 = repeat max
Number of averages
Compensate for interference from
existing signal. Turning this mode on
will significantly slow the measurement
but improve its accuracy when
interfering signals are present.
0 = off,
1 = on
Optimize for range or accuracy.
0 = accuracy
1 = range
Number of measurements averaged into
this data.
Time of measurement, instrument clock
seconds
Chapter 3