Agilent Technologies N1996A-503 User Reference page 86

Mode
Meas Off (Spectrum Analyzer) Measurement
Remote Command
Dependencies / Couplings
Remote Command
Example
Numeric Data Format (Remote Command Only)
This remote command specifies the format of the trace data input and output. It specifies
the formats used for trace data during data transfer across any remote port. It affects only
the data format for setting and querying trace data for the :TRACe[:DATA] and query
TRACe[:DATA]? commands.
The command syntax is:
Remote Command
86
:TRACe[:DATA] <trace_name>, <definite_length_block>|
<comma_separated_ASCII_data>
:TRACe[:DATA]? <trace_name>
where <trace_name> = TRACE1|TRACE2|TRACE3|TRACE4
the FORMat:DATA command describes the different types of data
formats that can be used with trace data.
use the FORMat:BORDer command to set the byte order.
:TRACe[:DATA]? TRACE1 | TRACE2 | TRACE3 | TRACE4
TRAC TRACE1,–1,–2,–3,–4,–5
Sends five points to Trace 1. Assuming that FORMat:DATA is set to
ASCII, Y Axis Unit is set to dBm, and sweep points is set to 5, this
will result in Trace 1 consisting of the five points –1 dBm, –2 dBm,
–3 dBm, –4 dBm, and –5 dBm.
TRAC? TRACE2 queries the analyzer for the contents of trace 2.
:FORMat[:TRACe][:DATA] ASCii | INTeger,32 | REAL,32 |
REAL,64
:FORMat[:TRACe][:DATA]?
Chapter 3