Agilent Technologies N1996A-503 User Reference page 241

Notes
Dependencies /
Couplings
Preset
State Saved
Min
Max
Key Path
Default Unit
2nd Segment
Sets the state of the first segment to On or Off. This key is available only when 2
selected with the Segments key.
Mode
Notes
Dependencies /
Couplings
Preset
State Saved
Range
Chapter 3
Key is only displayed when the selected segment is 2
selected segment side is Right.
st nd
If the Center, 1 , and 2
span adjusts on a change in the right 1
Not affected by a preset but set per default to 20 m (meters)
after a power cycling.
Saved in instrument state.
0 m (if Unit is Meters)
0 ft. (if Unit is Feet)
304.8 m (if Unit is Meters)
1000 ft. (if Unit is Feet)
Meas Setup, Limit Masks, Limit Mask 1, 1st Segment: Left Span
m (meters) if the "Unit" parameter is set to "Meter"
ft. (feet) if the "Unit" parameter is set to "Feet"
Stimulus / Response
Key is only displayed when the selected segment is 2
nd
If Off the 2 limit mask segment will not be displayed even if
turned On.
If On, and the First and Center segments are On:
nd
The left hand side 2 segment is drawn to the left hand side of
the left first segment at the specified power level
st
The right hand side 1 segment is drawn to the right hand side
of the right first segment at the specified power
The segment spans are calculated as documented in section
above
Off
Saved in instrument state.
On | Off
nd
segments On, the right 2
st
segment span.
nd
Mode
Distance To Fault
nd
, and the
segment
has been
nd
.
241