Agilent Technologies N1996A-503 User Reference page 248

Mode
Distance To Fault
placement does not change even if x axis settings subsequently are changed, although
y-axis settings will affect the vertical placement of data.
• In most cases, inactive traces are static and unchanging; however, there are cases when
an inactive trace will update, specifically:
— If data is written to that trace from a remote interface
— If trace data is loaded from mass storage
When a trace becomes active (
and the instrument prepares to begin a new sweep.
Dependencies / Couplings
Preset
State Saved
Key Path
Display Show/Blank
This key lets you make a trace visible or not. In
printouts but are otherwise unaffected. They may be queried and markers may be placed
on them.
Note that the action of putting a trace in
restart averaging or hold functions for any traces.
Dependencies / Couplings
Preset
State Saved
Key Path
View/Display Menu
To access the following keys for setting up a Distance to Fault measurement, press
Distance to Fault
and then the
248
Update On
= ), the trace is cleared, the average count is reset,
Setting the trace type (even to the type it was already in) puts the
Update = On
trace in
On Off
for Trace 1; for 2
Saved in Instrument State
Trace/Detector, Update On/Off (View)
Blank
Blank
does not restart the sweep and does not
• Setting the trace type (even to the type it was already in) puts
Show
the trace in
• Loading a trace from a file puts that trace in
of the state it was in when it was saved.
Show Blank
for Trace 1;
saved in Instrument State
Trace/Detector, Display Show/Blank
View/Display
key.
, traces do not display nor appear on
Show
for 2
regardless
Meas
,
Chapter 3