Agilent Technologies N1996A-503 User Reference page 187

Mode
State Saved
Preset
Range
Dependencies /
Couplings
Key Path
Cancel Use this key to abort the Calibration process.
Mode
Key Path
Meas
In the Stimulus Response mode,
Stimulus Response mode. The measurement runs using the current default setup. Or you
can change settings for your unique measurement requirements. Settings can be changed
using the functions available under the
To configure measurement settings, select
Setup
.
Control/Sweep
Use to restart the currently selected measurement and change the sweep
points. To select between continuous or single measurements, press the
front-panel keys. For information about controlling sweep, refer to
page 98.
Mode
State Saved
Range
Key Path
Chapter 3
Stimulus / Response
No
The same value as the Start Freq set for the measurement.
10 MHz to 3.0 GHz (Option 503) / to 6.0 GHz (Option 506)
The Calibration Stop Freq must be set higher that the
Calibration Start Freq. If you set the Calibration Stop Freq
lower then the Calibration Start freq, the start frequency will
automatically be set to a value lower that the stop frequency.
Freq/Channel Calibrate
,
Stimulus / Response
Freq/Channel Calibrate
,
Meas
accesses a menu of keys associated with the
Meas Setup
One Port Insertion Loss
Stimulus / Response
Saved in instrument state.
Two Port Insertion Loss | One Port Insertion Loss | Return Loss
| Distance to Fault
Meas
One Port Insertion Loss Measurement
key.
and then press
Cont
"Control/Sweep" on
Mode
Meas
Single
or
187