Agilent Technologies N1996A-503 User Reference page 234

Mode
Distance To Fault
Exponential Sets the
Averaging
each successive data acquisition is exponentially weighted and combined with the existing
average. This weights new data more than the old data, which facilitates tracking of slow
changing signals.
Key Path:
Repeat Sets
Averaging
to the repeat function. Repeat averaging updates the trace after the
selected number of sweeps has been averaged. It is not updated again until the next set of
Avg Number
data from sweeps has been collected.
Key Path:
Max Hold In
Max Hold
the analyzer maintains and displays a max hold trace, which
represents the maximum data value on a point-by-point basis of the new trace data and
previous trace data. Pressing the
Max Hold,
causes the trace to be cleared and causes the
Key Path:
Repeat Max Hold Sets
Averaging
captures and holds the highest magnitude data at the end of each sweep count. Repeat
with max hold updates the trace after the selected number of sweeps has been made. It is
not updated again until the next set of data from
Key Path:
Avg Number
Sets the number of measurement averages used when calculating the measurement result.
Mode
234
function to exponential. With exponential averaging mode,
Meas setup, Avg Mode, Exponential
Meas setup, Avg Mode, Repeat
Max Hold
key for the selected trace sets the trace type to
Meas setup, Avg Mode, Max Hold
to repeat with max hold function. Repeat with max hold
Avg Number
Meas setup, Avg Mode, Repeat Max Hold
Stimulus / Response
Max Hold
sequence to be restarted.
sweeps has been collected.
Chapter 3