Remote Command Notes
Preset
State Saved
Key Path
Chapter 3
This command stops the current measurement and sets up the
instrument for the specified measurement using the factory default
instrument settings. It does not initiate the taking of measurement
data. This command will always set :INITiate:CONTinuous OFF
(single sweep mode) and place the instrument in the idle state.
:CONFigure? à returns the current measurement name
:CONFigure:<meas_name>:NDEFaults
This command simply selects the specified measurement. It does not
affect the current instrument settings.
The measurement keywords that are available for these commands
depend on the current mode selected. They can include:
OBW (Occupied Bandwidth)
ACP (Adjacent Channel Power)
TPILoss (Two Port Insertion Loss
Spectrum Analyzer
Saved in instrument state.
Mode, Spectrum Analyzer
Mode
Spectrum Analyzer
29