Show Msglog; Show Running-Config; Show Sysinfo - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

show msglog

This command displays the message log maintained by the switch. The message log contains
system trace information.
The trap log contains a maximum of 256 entries that wrap.
Format
Mode
Message
Note: Message log information is not retained across a switch reset.

show running-config

This command is used to display/capture the current setting of different protocol packages
supported on switch. This command displays/captures only commands with settings/
configurations with values that differ from the default value. The output is displayed in script
format, which can be used to configure another switch with the same configuration.
When a script name is provided, the output is redirected to a configuration script. The option [all]
will also enable the display/capture of all commands with settings/configurations that include
values that are same as the default values. If the optional <scriptname> is provided with a file
name extension of ".scr", the output will be redirected to a script file.
Format
Mode
If static capability is enabled:
port-channel staticcapability

show sysinfo

This command displays switch information.
Format
Mode
Switch Description
System Name
Switching Commands
show msglog
Privileged EXEC
The message that has been logged.
show running-config [all] [<scriptname>]
Privileged EXEC
The device has static capability enabled.
show sysinfo
Privileged EXEC
Text used to identify this switch.
Name used to identify the switch.
202-10102-01, May 2005
8-13