Show Msglog - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Mac Address
slot/port
if Index
Status

show msglog

This command displays the message log maintained by the switch. The message log contains
system trace information.
The trap log contains a maximum of 256 entries that wrap.
Format
Mode
Message
Switching Commands
A unicast MAC address for which the switch has forwarding and
or filtering information. The format is 6 or 8 two-digit hexadeci-
mal numbers that are separated by colons, for example
01:23:45:67:89:AB. In an IVL system the MAC address will be
displayed as 8 bytes. In an SVL system, the MAC address will be
displayed as 6 bytes.
The port which this address was learned.
This object indicates the ifIndex of the interface table entry asso-
ciated with this port.
The status of this entry. The meanings of the values are:
Static The value of the corresponding instance was added by the
system or a user when a static MAC filter was defined. It cannot
be relearned.
Learned The value of the corresponding instance was learned by
observing the source MAC addresses of incoming traffic, and is
currently in use.
Management The value of the corresponding instance (system
MAC address) is also the value of an existing instance of
dot1dStaticAddress. It is identified with interface 0/1 and is cur-
rently used when enabling VLANs for routing.
Self The value of the corresponding instance is the address of one
of the switch's physical interfaces (the system's own MAC
address).
GMRP Learned The value of the corresponding was learned via
GMRP and applies to Multicast.
Other The value of the corresponding instance does not fall into
one of the other categories.
show msglog
Privileged EXEC
The message that has been logged.
December 2004, 202-10010-02
8-13