Show Interface Ethernet - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Time Since Counters Last Cleared
The display parameters, when the argument is 'switchport', is as follows :
Packets Received Without Error
Broadcast Packets Received
Packets Received With Error
Packets Transmitted Without Error
Broadcast Packets Transmitted
Transmit Packet Errors
Address Entries Currently In Use
VLAN Entries Currently In Use
Time Since Counters Last Cleared

show interface ethernet

This command displays detailed statistics for a specific port or for all CPU traffic based upon the
argument.
Format
Mode
The display parameters, when the argument is '<slot/port>', are as follows :
Packets Received
8-4
The elapsed time, in days, hours, minutes, and seconds
since the statistics for this port were last cleared.
The total number of packets (including broadcast packets
and multicast packets) received by the processor.
The total number of packets received that were directed to the
broadcast address. Note that this does not include multicast packets.
The number of inbound packets that contained errors preventing
them from being deliverable to a higher-layer protocol.
The total number of packets transmitted out of the inter-
face.
The total number of packets that higher-level protocols
requested to be transmitted to the Broadcast address, including those
that were discarded or not sent.
The number of outbound packets that could not be transmitted because
of errors.
The total number of Forwarding Database Address Table
entries now active on the switch, including learned and static entries.
The number of VLAN entries presently occupying the VLAN
table.
The elapsed time, in days, hours, minutes, and seconds
since the statistics for this switch were last cleared.
show interface ethernet
Privileged EXEC
Octets Received - The total number of octets of data (including those in
bad packets) received on the network (excluding framing bits but
including Frame Check Sequence (FCS) octets). This object can be used
as a reasonable estimate of ethernet utilization. If greater precision is
202-10102-01, May 2005
slot/port
{< > | switchport}
Switching Commands