Mode-Based Cli - NETGEAR 7300 Series User Manual

User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
The CLI groups all the commands in appropriate modes according to the nature of the command.
A sample of the CLI command modes are described below. Each of the command modes support
specific 7300 Series L3 Switch commands.
• User Exec Mode
• Privileged Exec Mode
• Global Config Mode
• Vlan Mode
• Interface Config Mode
• Line Config Mode
• Policy Map Mode
• Policy Class Mode
• Class Map Mode
• Router Config OSPF Mode
• Router Config RIP Mode
• DHCP Pool Configuration Mode
The Command Mode table captures the command modes, the prompts visible in that mode and the
exit method from that mode.
Table 7-1. Command Mode
Command Mode
User Exec Mode
Privileged Exec Mode

Mode-based CLI

Access Method
This is the first level of
access. Perform basic
tasks and list system
information.
From the User Exec
Mode, enter the enable
command.
202-10009-01_060204
Mode-based CLI
Prompt
Switch>
Switch#
Chapter 7
Exit or Access Next
Mode
Enter Logout command
To exit this mode, enter
exit or press Ctrl-Z.
7-1