Mode-Based Cli - NETGEAR ProSafe GSM7212 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
The CLI groups all the commands in appropriate modes according to the nature of the command.
A sample of the CLI command modes are described below. Each of the command modes support
specific 7200 Series L2 Switch commands.
• User Exec Mode
• Privileged Exec Mode
• Global Config Mode
• Vlan Mode
• Interface Config Mode
• Line Config Mode
The Command Mode table captures the command modes, the prompts visible in that mode and the
exit method from that mode.
Table 7-1. Command Mode
Command Mode
User Exec Mode
Privileged Exec Mode
VLAN Mode

Mode-based CLI

Access Method
This is the first level of
access. Perform basic
tasks and list system
information.
From the User Exec
enable
Mode, enter the
command.
From the Privileged
User Exec mode, enter
vlan database
the
command.
December 2004, 202-10010-02
Mode-based CLI
Prompt
Switch>
Switch#
Switch (Vlan) #
Chapter 7
Exit or Access Next
Mode
Enter Logout command
To exit this mode, enter
exit or press Ctrl-Z.
To exit to the Privileged
Exec mode, enter the
exit command, or press
Ctrl-Z to switch to user
exec mode.
7-1