Default-Router; No Default-Router; Dns-Server; No Dns-Server - NETGEAR ProSafe GSM7248 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

default-router

This command specifies the default router list for a DHCP client. {
are valid IP addresses, each made up of four decimal bytes ranging from 0 to 255. IP address
0.0.0.0 is invalid.
Default
Format
Mode

no default-router

This command removes the default router list.
Format
Mode

dns-server

This command specifies the IP servers available to a DHCP client. Address parameters are valid IP
addresses; each made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default
Format
Mode

no dns-server

This command removes the DNS Server list.
Format
Mode

hardware-address

This command specifies the hardware address of a DHCP client.
Hardware-address is the MAC address of the hardware platform of the client consisting of 6 bytes
in dotted hexadecimal format.
Switching Commands
None
default-router <address1> [<address2>....<address8>]
DHCP Pool Config
no default-router
DHCP Pool Config
none
dns-server <address1> [<address2>....<address8>]
DHCP Pool Config
no dns-server
DHCP Pool Config
202-10102-01, May 2005
address1, address2... address8
}
8-83