User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
Mode
default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
Mode
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
Format
Mode
default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Format
Mode
no default-metric (OSPF)
This command is used to set a default for the metric of distributed routes.
Format
Mode
default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
Format
Mode
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
Routing Commands
Router OSPF Config
default-information originate
Router RIP Config
no default-information originate
Router RIP Config
default-metric <1-16777215>
Router OSPF Config
no default-metric
Router OSPF Config
default-metric <0-15>
Router RIP Config
202-10009-01_060204
9-15