Software Installation and Configuration
Updating System Components
Various files used in the previous version may need to be changed before the new version can
be used.
• Configuration files (such as e3238s.cfg)
• Resource file (the E3238s file, if used)
• Custom library extensions
Configuration File Update
When the installation program
is run, a new configuration file is installed as
setup.exe
\E3238s\d.e3238s.cfg (overwriting the previous copy). You should compare the
configuration file(s) in use against this one and convert the usage as appropriate to be
compatible with new capabilities.
Resource File Update
The application resource file \E3238s\d.E3238s should also be compared to the resource file
in use (E3238s).
Updating Custom Libraries
It may be necessary to recompile any custom libraries which you have created. An upgrade
note describing the details should accompany the material sent as an upgrade kit.
New versions of libraries purchased from Agilent should be delivered to you on separate CDs
as part of the upgrade.
For System Recovery
To recover the system from something like replacement of the system disk, first recover the
controller operating system using the recovery disks provided with the controller and then
perform an installation with the most recent version of the E3238S software. See
Installing
and Configuring the E3238S Software (page
69).
Note
The E3238S software requires a valid copy of your software license file. If you do not have a
valid license file, contact Agilent to have one regenerated and e-mailed to you. See
The
Software License File (page
82).
64