Reading Out Sort Count Of Each Bin (Bin Count Function); Turning On/Off Bin Count Function; Reading Out Bin Count Value; Clearing (Resetting) The Bin Count Value - Agilent Technologies 4288A Programming Manual

Sorting Based on Measured Result (Comparator Function)

Reading Out Sort Count Of Each Bin (BIN count function)

Reading Out Sort Count Of Each Bin (BIN count function)

Turning ON/OFF BIN count function

To turn ON/OFF the BIN count function, use the following command.
:CALC:COMP:COUN on page 137
•
You can count the number of DUTs sorted into each BIN by turning ON the BIN count
function. The maximum value of the count is 999999. If this value is exceeded, the count
does not continue to increase but remains at 999999 (does not return to 0).
When the MULTI compensation function is ON (set to ON with :CORR:MULT command
on page 161), a channel-by-channel count is performed in addition to the normal count
(total of all the channels).

Reading out BIN count value

To read out the BIN count value, use the following commands:
:CALC:COMP:COUN:DATA? on page 138
•
• :CALC:COMP:COUN:OVLD? on page 140
To read out the BIN count value for each channel when the MULTI compensation function
is ON, use the following commands:
:CALC:COMP:COUN:MULT:DATA? on page 139
•
:CALC:COMP:COUN:MULT:OVLD? on page 140
•

Clearing (resetting) the BIN count value

To clear all of the BIN count values (initialize to 0), use the following command.
:CALC:COMP:COUN:CLE on page 137
•
88 Chapter 7