Programming Transmitters; Slide-Out Operation; Safety Precautions; Front And Rear Slide-Out Operation - PREVOST H3-45 VIP Owner's Manual

5-32 Other Features

PROGRAMMING TRANSMITTERS

Up to 20 transmitters can be used with the keyless
entry system. To add or replace transmitters, the
system must be first put into learn mode using the
vehicle keypad.
To program transmitters perform the following steps:
Hold the 5/6 button of the keypad for 5
l
seconds (keypad will start to beep and flash).
Enter the vehicle factory six (6) digit authority
l
code.
Hold button 7/8 for 5 seconds, a double beep
l
will play, confirming that the system is now in
learn mode.
Press the lock button on each transmitter to
l
be programmed for 5 seconds with a two
seconds pause between each transmitter.
Press the 9/0 button twice to exit learn mode
l
(the keypad will beep twice and stop
flashing).
NOTE
If more than 20 transmitters are programmed,
additional transmitters will over-write the first ones.

SLIDE-OUT OPERATION

Due to the high current demand and safety
requirements of the slide-out system, room operation
is on a "first in first served" basis, meaning only one
slide-out unit may be operated at a time.

SAFETY PRECAUTIONS

Before operating both slide-out units, proceed to the
following verifications:
Make sure that the area outside of the slide-
l
out is clear and that there are no persons or
objects within 3 feet of the slide-out outside
wall. Serious personal injury or damage to the
vehicle components may occur.
Make sure that the area inside the motor
l
home where the room retracts (30" for the
front and 24" for the rear slide-out) is free of
people or obstacles. Serious personal injury
or damage to the vehicle components may
occur.
In temperatures below freezing point, make
l
sure that the entire sliding surface outside the
slide-out is free of snow, ice or sleet. Failure

FRONT AND REAR SLIDE-OUT OPERATION

Before extending or retracting the slide-out, please
make sure all the following conditions are met:
Before extending or retracting the slide-out, always
open a window to avoid movement restriction and
to prevent the motor from stopping in overcurrent
because of a vacuum or pressure build up inside
the vehicle.
FAST IDLE BUTTON
Slide-out Extending Operation
With the ignition switch to the "ON" position and the
engine running, press and hold down the rocker
switch on the control pad to the "OUT" position. The
green indicator light "ROOM IN OPERATION" will
come on to indicate that the slide-out operation cycle
PA-1638 Owner's Manual X3-45 VIP
to clear all ice or snow may seriously damage
the inflatable seal.
The parking brake must be applied.
l
The transmission must be in the "NEUTRAL"
l
position.
Open a window to avoid slide-out movement
l
restriction.
Level the vehicle.
l
1. Make sure the air pressure is 110 psi
minimum on the auxiliary air pressure gauge.
2. Make sure the parking brake is applied and
that transmission is in the "NEUTRAL"
position.
3. Turn the ignition key to the "ON" position,
start the engine and set the RPM to fast idle.
CAUTION