Remote Entry Transmitter; Programming Transmitters; Slide-Out Operation; Safety Precautions - PREVOST X3-45 VIP 2015 Owner's Manual

Re-enter the code to confirm the deletion
o
(four confirmation beeps will be heard).
Repeat the process to delete additional codes.

REMOTE ENTRY TRANSMITTER

Hand held transmitters (key FOB) can be used
to control the keyless door lock system.
To lock the entrance door and the baggage
compartment doors simultaneously and arm
the intrusion protection
system:
Press LOCK (top) button on the transmitter
o
once.
NOTE
The lock function will not function when the
ignition is in the ON position or the entry door
is open.
NOTE
The intrusion protection and anti-theft system
will be set after a 10 seconds delay.
To unlock the entrance door:
Press UNLOCK DOOR (bottom) button on
o
the transmitter. This will unlock the door and
disarm the anti-theft system.
To unlock the baggage compartment doors:
Press UNLOCK BAGGAGE (right) button.
o
This will not disarm the alarm.
To set off the personal security alarm (Panic
mode):
Press and hold the red (left) PANIC button
o
for two seconds. The horn will sound and
the marker lights will flash for 30 seconds.
To deactivate the personal security alarm:
Press any FOB button again or unlock the
o
entrance door using the keypad.
and anti-theft
Other Features

PROGRAMMING TRANSMITTERS

Up to 20 transmitters can be used with the
keyless entry system. To add or replace
transmitters, the system must be first put into
learn mode using the vehicle keypad.
To program transmitters perform the following
steps:
o
Hold the 5/6 button of the keypad for 5
seconds (keypad will start to beep and
flash).
o Enter the vehicle factory six (6) digits
authority code.
o Hold button 7/8 for 5 seconds, a double
beep will play, confirming that the system is
now in learn mode.
o
Press the lock button on each transmitter to
be programmed for 5 seconds with a two
seconds pause between each transmitter.
o
Press the 9/0 button twice to exit learn mode
(the keypad will beep twice and stop
flashing).
NOTE
If more than 20 transmitters are programmed,
additional transmitters will over-write the first
ones.

SLIDE-OUT OPERATION

SAFETY PRECAUTIONS

Before operating both slide-out units, proceed to
the following verifications:
•
Make sure that the area outside of the slide-
out is clear and that there are no persons or
objects within 3 feet of the slide-out outside
wall. Serious personal injury or damage
to the vehicle components may occur.
•
Make sure that the area inside the motor
home where the room retracts (30" for the
front and 24" for the rear slide-out) is free of
people or obstacles. Serious personal
injury or damage
components may occur.
•
In temperatures below freezing point, make
sure that the entire sliding surface outside
the slide-out is free of snow, ice or sleet.
Failure to clear all ice or snow may
seriously damage the inflatable seal.
•
The parking brake must be applied.
5-27
to the vehicle