Ipx Lan Interface Parameters; Ipx X.25 Interface Parameters - Cabletron Systems SmartSwitch 6000 User Manual

Watchdog Spoofing Enabled
LAN Card Number
IPXWAN Enabled
Source Subscriber
12-14
Disabling serialization allows filtering of these broadcasts to reduce WAN traffic, and
is not intended to interfere with copyright-protection mechanisms.
determines whether this interface will be used by the local node to respond to "keep-
alive" messages on behalf of the client workstations. Novell servers periodically issue
these messages to all clients, to determine whether each client is still available.
Table 12-8 IPX LAN Interface Parameters
Parameter
LAN Card Number
identifies the card. The first or only LAN card installed is always card
second is card . (Although the FRX4000 does not have a LAN card, it's LAN
1
interface is identified as
Table 12-9 IPX X.25 Interface Parameters
Parameter
IPXWAN Enabled
Source Subscriber
Destination Subscriber
SVC Retry Timer (seconds)
SVC Idle Timer (minutes)
Max VCs to Establish
PVC Connection
The addresses specified here must also be configured in Subscriber records, with certain
1
requirements. These are described in Chapter 7.
determines whether Novell's IPXWAN protocol will be used on the interface.
IPXWAN specifies a method for IPX routers to communicate across WAN links. FRX
and FRM implement IPXWAN running over RFC 1490-compliant frame relay and
RFC1356-compliant X.25.
is a subscriber ID that defines an IPX interface in the node, by associating itself with
port (a number reserved for the IPX interface) on the RLP that has IPX installed on
66
it (or simply port in an FRX4000). (See the footnote following Table 12-9.)
66
Valid Values
FRX4000, FRM:
FRX6000:
.)
0
Valid Values
Y/N
valid subscriber address
valid subscriber address
5–60
0–5
1–8
Y/N
Default Value
0
0–1 0
, and the
0
Default Value
N
1
none
1
none
20
1
1
N
FRX/FRM 3.3 User Guide, Rev 04