Cabletron Systems SmartSwitch 6000 User Manual page 276

15-4
C SDLC PU Status
specified SNA port, including current active/inactive states.
D Bridge Status Displays
A Bridge Port Status Display
type, active status, bridge state (forwarding, listening, etc.), and number
of bytes received and transmitted.
B Bridge Forwarding Table Display
their associated bridge ports, plus any flags that have been set.
E Frame Relay Backup Status
primary and backup DLCIs.
A Display States for all Backup DLCIs on a Port
B Display States for all Primary DLCIs on a Port
C Display States for all Backup DLCIs in a Group
F LLC/2 Session Status
current LLC2 sessions.
G IP Routing Table Display
and flags.
H IP ARP Table Display
aging timers.
I IP Interfaces Display
names, masks, IP and remote addresses, and flags.
– (Chapter 18) Displays event (alarm) messages as they occur.
D Events
(Chapter 17)
E Statistics
A Configure LP/Port Thresholds
when crossed, will cause an alarm to be generated.
B Display LP/Port/Frame Statistics
specified component, showing current values, as well as the highest values
reached by each statistic since the node was last booted or since maximum
values were last cleared.
C Display IP Statistics
and cumulative values since maximum values were last cleared.
D Display ICMP Statistics
values and cumulative values since maximum values were last cleared.
E Display IP Interface Statistics
current values and cumulative values since maximum values were last
cleared.
F Display IPX Interface Statistics
current values and cumulative values since maximum values were last
cleared.
G Display LAN Card Interface Statistics
including current values and cumulative values since maximum values
were last cleared.
H Display Frame Relay Utilization Statistics
a specified DLCI, as well as the configured and actual percentages of
bandwidth use by each bandwidth allocation group.
F Reports
A Create Configuration Report
records in the node.
B View Configuration Report
C View Initialization Report
during the current boot-up of a node.
D View Previous Initialization Report
created during the previous boot-up of a node.
– displays a list of configured station addresses for a
– displays a list of Bridge ports, including
– displays a list of MAC addresses and
– displays the current state of frame relay
– displays addresses and operational states of all
– displays interfaces, destinations, network masks,
– displays ARP IP addresses, MAC addresses, and
– displays interface names, MTU values, network
– allows creation of a threshold for a statistic that,
– displays the supported statistics for the
– displays the supported statistics, including current values
– displays the supported statistics, including current
– displays the supported statistics, including
– displays the supported statistics, including
– displays the supported statistics,
– displays CIR, B
– (Chapter 2) produces a summary of all database
– (Chapter 2) displays the above summary.
– (Chapter 1) produces a list of messages created
– (Chapter 1) produces a list of messages
, and B values for
E C
FRX/FRM 3.3 User Guide, Rev 04