Cabletron Systems SmartSwitch 6000 User Manual page 168

Remote Subscriber ID
IDBLK
IDNUM
Maxdata
MaxIn
8-26
connection, this address must match the
LLC2 Host record.
is the subscriber address assigned to the remote end of the SNA connection. If config-
uring an LLC2-to-SDLC link, this address must match the
figured in the SNA port record for the SDLC device. If configuring an LLC2-to-LLC2
connection, this address must match the
Host record.
is used in conjunction with
(format 0 or 3) to establish a link station connection to the host. A further explanation
is provided under "
IDNUM
is used in conjuction with
0 or 3) to estblish a link station connection to the host. If both IDBLK and IDNUM
are set to , the Node field of the XID will be provided by the attached SDLC device.
0
(The node will send an XID command to the remote node to indicate that the SDLC
device should be polled for an XID.)
must correspond to the PIU size configured on the host (parameter
PU in VTAM). For a link between a PU type 4 and a PU type 2, the frame size con-
figured for the HPAD and TPAD SNA ports must be set at the value of MAXDATA
in VTAM plus 6 bytes (corresponding to the length of the link header and the link
trailer).
is the maximum number of sequentially numbered Information LPDUs that the link
station can have outstanding.
Remote Subscriber ID
Local Subscriber ID
in generating the Node field in an XID frame
IDNUM
."
in generating the Node field in an XID frame (format
IDBLK
in the remote node's
con-
Local Subscriber
in the remote node's LLC2
of macro
MAXDATA
FRX/FRM 3.3 User Guide, Rev 04