Cabletron Systems SmartSwitch 6000 User Manual page 93

Configuring DLCI Parameters (Figure 6-4, Item D)
Configuring Frame Relay
backup configurations. In the example in Figure 6-5, DLCI 50 is a primary. All the
parameters are listed in Table 6-3 (on page 6-15).
The parameters in the first line are:
, , are self-explanatory.
RLP Port DLCI
=
ICIR Committed Information Rate (In)
=
IBC Committed Burst Size (In)
=
IBE Excess Burst Size (In)
=
OCIR Committed Information Rate (Out)
=
OBC Committed Burst Size (Out)
=
OBE Excess Burst Size (Out)
=
BECN BECN Recovery Count
=
Pri Outgoing DLCI Priority
=
Proto Enable BackupProtocol
The parameters in the second line are:
=
Grp Backup Group Number
=
RRLP Remote RLP
=
RPrt Remote Port
=
RDLCI Remote DLCI
=
SOT Switchover Timer
=
SBT Switchback Timer
=
TTH Time to Hold Data While Waiting
To configure DLCI parameters (listed in Table 6-3), press
prompted, enter a
DLCI ID:
similar to Figure 6-6.
With the exception of frame relay backup DLCIs, DLCIs are not created
here, but in Frame Relay PVC or IP/IPX/LLC2 interface configuration.
The port parameters relating to non-frame relay backup DLCIs are rate
control parameters for existing DLCIs.
. (The default is
16–991
at Figure 6-4 and, when
[D]
.) This will display a screen
16
6-11