Subscriber Parameters; Svc Subscriber Parameters - Cabletron Systems SmartSwitch 6000 User Manual

Subscriber Parameters

Subscriber Name
Routing Algorithm
Configuring BSC
Parameter
Subscriber Name
Routing Algorithm
Systematic Redirection
Redirect on Busy
Redirect on Out of Order
Connection Priority
1st,2nd,etc. Path Configured
LP
Por t
Redirection Address 0,1,etc.
1 The software does not verify that the specified LP/port exists. Make sure the specified
LPs and ports are configured in the database, and that they actually exist.
identifies the subscriber to the console operator. The FRX/FRM software does not use
this information.
allows creation of a "hunt group" of ports (see example in Appendix B), for the
purpose of routing per a pre-selected algorithm:
= Round Robin – selects ports specified cyclicly in numerical order according
0
to the list of Redirection Addresses. If the selected port is unreachable or con-
gested, the Call Request will be sent to the next port. (If the port becomes
available again, it will be included in its assigned position.)
= Alternate Route on Line Failure – selects the first port that is not in a failed
1
state. If the selected port does not make a connection, the call will be cleared, even
if other ports are available.
= Alternate Route on Line Busy – selects the first port that has LCNs available
2
(is not busy). If the port has failed, the next available port will be selected.
= Least LCN with Throughput – selects the line with the minumum loading, cal-
3
culated by weight and number of LCNs in use on that line. (Each line is assigned
a weight proportional to its throughput within the routing path.)
If use of a routing algorithm is not desired, simply accept the default, and specify only
one routing path.
Table 9-3 SVC Subscriber Parameters
Valid Values
0–31 characters
0–3
Y/N
Y/N
Y/N
0–9
Y/N
FRX4000, FRM:
FRX6000:
Physical port:
Logical port:
valid address
Default Value
none
0
N
N
N
0
N
1
0
1
0–7
0
1
0–7
1
8–63
0
none
9-17