Frame Relay Dlci Configuration Screen 1 - Cabletron Systems SmartSwitch 6000 User Manual

6-12
Frame Relay DLC I C onfiguration (s creen 1 of 2)
* LP
* Port
* DLCI
A Committed In formation Rate (I n)
B Committed Burst Size (In)
C Excess Burst Size (In)
D Committed In formation Rate (Out)
E Committed Burst Size (Ou t)
F Excess Burst Size (Ou t)
G BECN Recovery C ount
H Ou tgoin g DLC I Priority
I DLCI Backup C onfiguration
Option:
Figure 6-6 Frame Relay DLCI Configuration Screen 1
Pressing at this or the subsequent screen (Figure 6-7) will delete the
[F4]
DLCI rate control and backup configuration. (The port will not be deleted
unless is pressed at one of the higher-level port screens—Figure 6-3
[F4]
and Figure 6-4.)
Note that the DLCI is not yet deleted. If it was created solely for frame relay
backup, it will remain in existence until the node is rebooted. If the DLCI was
created when configuring an IP, IPX, or LLC2 interface, it will remain until
that interface is deleted and the node is rebooted.
If a primary DLCI is brought down, then deleted from the
database while the backup is operational, end-to-end connec-
tivity over the backup will fail. For this reason, a primary DLCI
should never be deleted. (If there is a need to delete the DLCI, it
should first be re-configured so that it is not part of a frame relay
backup situation.)
Nod e Name=n ode_xyz
0
7
16
2000
2000
1000
2000
2000
1000
8
0
FRX/FRM 3.3 User Guide, Rev 04