Cabletron Systems SmartSwitch 6000 User Manual page 275

Introduction to System Operation
still active connections on the port).
H Unquiesce a Range of Ports
ports.
C On-Line Database Operations
files locally or remotely.
A Back up the Current Database to a Remote FRX6000
from an FRX4000 or FRX6000 onto a diskette at a remote FRX6000.
B Restore the Backed-Up Database to a Remote FRX6000
database backed up by the above operation to the hard disk at the remote
FRX6000.
C Restore the Backed-Up Database to a Remote FRX4000
D Back up the Current Database to a Local Directory
E Restore the Database from a Local Directory
F Back Up the Current System Files to a Local Directory
G Restore the System Files from a Local Directory
D Test X.25 Address Translation Templates
assure they were correctly created.
E Re-Load Initialization to Async Console
settings to an Auxiliary Console on the node's Console port (FRX4000) or
COM1 port (FRX6000 or FRM).
F IP Ping Connectivity Test
whether an IP host is reachable.
G On-Line SDLC PU Operations
A Disable an SDLC PU
B Disable a Range of SDLC PUs
C Enable an SDLC PU
D Enable a Range of SDLC PUs
H NetView Access
information on the node via NMVT commands or from files in the node
database.
– (Chapter 16)
I CSU/DSU Tests
– transmits a test pattern to the analog portion of the circuitry and
A Self Test
loop the pattern back to itself.
B Pattern Generation Test
test pattern to the remote device, which will loop the signals back.
J Frame Relay Backup Operations
a primary frame relay DLCI to its backup, or from the backup to the primary,
without configuring a backup group in the database.
A Initiate Switching Primary DLCI Over to its Backup
B Initiate Switching DLCI Back to the Primary
(Chapter 17)
C Status Displays
– displays performance and link status for the node.
A Node Status
– displays port type, operational status, and link states for all ports
B Port Status
on the node.
C Virtual Connections
(frame relay only) performance for all logical connections.
– displays configuration data for each port on a specified LP
D Port Signals
(FRX6000) or in the node (FRX4000, FRM), and shows on/off status of
each signal at the interface.
– displays control and information data of all level-3 packets
E Line Monitor
passing through a specified X.25 port.
F Protocol Status
A IPX RIP Table Display
B IPX SAP Table Display
– Unquiesces a specified group of same-type
– (Chapter 16) backs up database and/or system
– (Chapter 16) Sends default terminal
– (Chapter 16) Uses the Ping function to determine
(Chapter 8)
– Takes any SDLC PU in the node off line.
– Takes a group of PUs off line.
– Brings any SDLC in the node on line.
– Brings a group of PUs on line.
– (Appendix E) allows a NetView manager to obtain
– transmits a PRBS (pseudo-random bit sequence)
– (Chapter 16) allows manual switching from
– displays DLCIs/LCNs, link states, subscribers, and
– displays the contents of the RIP table.
– displays the contents of the SAP table.
– copies the database
– copies the
– (Chapter 7) Tests templates to
15-3