Database And System Memory Values - Cabletron Systems SmartSwitch 6000 User Manual

Database and System Memory Values

Copying Values Between Sets
5-4
Two sets of values exist for Port and Channel parameters: Database values exist in the
software, and are recorded as System Memory values when the node is booted. If the
parameter is the same in both sets of values, both sets will be displayed, with
Port Type
an entry called
On-Line System Memory Changes
will affect the
System Memory
If you change
Port Type
On-Line System Memory Changes
this parameter toggles the display between the
Pressing after making changes to one set of values will copy those changes to the
[F7]
other set. However, changes will not be actually be saved to the database until you
press to exit the record.
[F3]
Pressing will display:
[F7]
you press , the link will be disabled, parameters copied, and the link re-enabled. If
[Y]
you press , you will be prompted:
[N]
Pressing
without disable?
not require disabling the link. Pressing
side; if , the
N Database
in one set of values, only that set will now be displayed, and
will be replaced by
System Memory
On-line changes disable link, are you sure you want to?
Do you want to change port parameters partially
will propagate any changes to those parameters that do
[Y]
will return you to the next higher screen.
[N]
. If this is , any changes you make
Y
side will change.
Database Display (Y/N)
and
Database
FRX/FRM 3.3 User Guide, Rev 04
. Selecting
values.
If